FEP+ for GPCR

2/25/2021 Ying Yang

Steps for setting up a FEP prediction for membrane protein

Protein side

• Begin by importing the structure of interest with a ligand that you are confident about. (FEP works best with an experimentally determined structure but can work with a docked pose if you are careful).

• Run the protein preparation wizard on your protein. Think carefully about protonation, you might even consider using the interactive protonation function to optimize the protonation state of the binding site residues or allosteric control points manually.

Protein model completeness Protein preparation should include fixing any chain breaks, modeling in any loop conformations and adding any missing side chains. Chain breaks near the active site will likely lead to poor results. Disulfide bridges should be created and termini residues capped where applicable.

Equilibration of complex structure (with confident binding pose)

• Build membrane using the System Builder tool. Use residue information obtained from OPM database (https://opm.phar.umich.edu/), add salts, add solvent. Default settings work well for most situations.

 res.num 76-97,112-136,141,143,146-171,194-215,227-229,231-256,323-345,347,360-380,382,398

• Use the Molecular Dynamics tool to write out a simulation file to run on the cluster. Load the system you built in the previous step from the workspace. Specify a simulation time, for high confidence complexes, 20 ns should suffice. For more exploratory complexes and to assess stability of the ligand extend to 50-100 ns. Use the default Schrodinger protocol to relax the model system before starting the production run of the simulation. For ease of evaluation, you can check the box to output interaction analysis at the completion of the job. Instead of clicking run, click the gear to the left of the run button and write the file out to the disk.

• Replace the gimel-biggpu in the written out simulation job with the correct gpu location, gimel5.heavygpu then transfer (scp) the simulation job to gimel5, and submit

 sed -i 's/gimel-biggpu/gimel5.heavygpu/g' desmond_md_job_1.sh
 bash desmond_md_job_1.sh

• Analyze the MD simulation

Visualize the trajectory and analyze the simulation with SID tool

• Convert -out.cms into mae

 $SCHRODINGER/run membrane_cms2fep.py -ligand 'ligand' 2A_NBOH_MD-out.cms -o relax_2A_NBOH_pv.mae

• Kill a submitted or running job:

 $SCHRODINGER/jobcontrol -kill <jobID>

Ligand side

Careful preparation of the ligands is critical to a successful FEP+ prediction. Best practices include running LigPrep on all the compounds to exhaustively enumerate all the stereoisomers and likely protonation states of the ligands. Note that triply-substituted ammonium cannot invert stereochemistry during the simulation, making it important to model both pseudo-stereoisomers.

• Force field builder

Run force field builder for all ligands

• Flexible ligand alignment OR core constrain docking

Depends on how similar/different are the ligands to the reference/center ligand

• Create FEP maps

• Write out the submission file; change host; submit on gimel5 via slurm